STM32 : Internet Of Things with 4G LTE Modem - Hardware

STM32 : Internet Of Things with 4G LTE Modem - Hardware

"If you want to learn hardware designing then think about taking this course, I promise, you will never be disappointed"

Note : This course is designed for electronics enthusiast and also for the advanced audience, please check course content before subscribing to this course. I can assure you, you will never regret spending your valuable money on this course.

This course is not just a PCB Design course but it's a complete hardware design course and covers all the aspects of hardware design which a hardware Designer has to go through in his professional life.  The purpose of this course to develop a sense of hardware based product design in the student. All sections of this course is structured in following manner.

1. Introduction to section

2. Datasheet explanation

3. Circuit design explanation

4. Components selection

5. Schematic design

6. Layout Design

7. Complete soldering process

8. Testing, Troubleshooting & Demonstration

9. Mistakes to avoid

We created this course because we believe that, its important how much knowledge you have but even more important thing is at what age you have it. Normally it takes time to develop skills in hardware and in this course we are sharing our experience and giving you a right approach to develop your skills in hardware designing. Which will help you to avoid mistakes and gain more knowledge in less time.

A quote that we want to share with you

"Learn from other peoples mistakes

Life is too short to make them all yourself"

- Sam Levenson

Our Promise...!!!

One thing that we can promise you is this course is going to save your lot of time to learn hardware designing. I will personally answer your questions about this course . If you are in any way not satisfied, for any reason, you can get a full refund from Udemy within 30 days with no questions asked. But we am confident you won't need to. We stand behind this course 100% and we are committed to helping you.

*******************************************************************************************************************

This course is an application oriented course that teaches hardware designing considering a 4G GSM Modem based IOT application. The hardware is based on Microcontroller from worlds leading semiconductor manufacturer "ST Microelectronics" & 4G LTE Modem from "SIMCOM". Both STM32 Microcontroller & SIMCOM Modem are most widely used for industrial IOT based application.

This course is mainly divided in three sections and covers the detailed procedure in their respective sections. For that you can check the course content.

• Power Supply Section

  • Switch Mode Power Supply

  • Li-Ion Battery Charger

  • Low Dropout Regulator (LDO)

• STM32 Microcontroller Section

• 4G LTE Modem Section

  • Modem Power Supply Design

  • Modem ON/OFF mechanism

  • Modem UART Interface

  • Modem USB 2.0 Interface

  • Modem USIM Interface

  • Modem SD Card Interface

  • Modem Network & Status

  • Modem Antenna : Mains & Diversity

  • Modem Antenna : GNSS

  • Modem DFU (Device Firmware Upgrade)

  
  

"If you want to learn hardware designing then think about taking this course, I promise, you will never be disappointed"

Industrial IOT Electronics Circuit Design & PCB Design course using STM32 Microcontroller & SIMCOM 4G GSM Modem

Url: View Details

What you will learn

• Industrial IOT Hardware Design, Electronics Circuit Design, Eagle PCB Design, Hardware Development Process
• Interface design & Layout : STM32 MCU, 4G LTE GSM, USB 2.0, SD Card, SIM Card, Antenna design (GSM & GNSS), SMPS, LDO, Li-Ion Battery Charger, USB2UART
• Detailed Circuit Design Process, Component Selection, Soldering, Testing & Troubleshooting using DSO, Practical demonstration

Rating: 4.9

Level: All Levels

Duration: 47 hours

Instructor: Cipher2Infinity .