Creo 2.0 SheetMetal design

Creo 2.0 SheetMetal design

In this course, you will learn

• The sheet metal design process

• Sheetmetal model creation, conversion, and display

• Methods of developed length calculation

• Primary wall features

• Secondary wall features

• Partial walls

• Bend relief

• Unbend and bend back features

• Sheetmetal bend features

• Flat patterns

• Sheetmetal cuts

• Forms

• Notch and punch features

• Sheetmetal environment setup

• Sheetmetal design Information tools

• Sheetmetal design rules

• Detailing sheetmetal designs

Topics Covered:

1: Introduction to the Creo Parametric Sheetmetal Design Process

2: Sheetmetal Model Fundamentals

3: Creating Primary Sheetmetal Wall Features

4: Creating Secondary Sheetmetal Wall Features

5: Bending and Unbending Sheetmetal Models

6: Modifying Sheetmetal Models

7: Sheetmetal Setup and Tools

8: Detailing Sheetmetal Designs

About Sheetmetal Design Properties

Sheet metal properties and their associated settings can be used to predefine common feature geometry, automate tasks, and maintain design consistency for sheet metal parts. The values of these settings depend on any predefined sheet metal parameters. The following properties specific to sheet metal are available in the Sheetmetal section of the Model Properties dialogue box:

• Bend Allowance—Displays the factor type for bend allowance calculations and whether a bend table is assigned to the model.

• Bends—Displays the radius size and the location for dimensioning bends.

• Relief—Displays the type of bend and corner relief.

• Edge Treatment—Displays the type of edge treatment.

• Miter Cuts—Displays the width and offset of miter cuts.

• Fixed Geometry—Displays the part geometry to remain fixed during unbend, bend back, and flat pattern operations.

• Bend Order—Displays the number of bend order sequences defined for a model.

• Design Rules—Displays the number of design rules defined for a model.

• Flat State Instances—Displays the number of flat state instances defined for a generic model created in legacy releases older than Creo Parametric

SheetMetal Design In Creo Parametric 2.0

Url: View Details

What you will learn

• Creo
• Sheet Metal Modeling In Creo

Rating: 3.21429

Level: Expert Level

Duration: 6.5 hours

Instructor: Krishnamurthy Ananthasayana